Once you are unchoked you can make requests for data to the peer - see the "out reqs" column. The choking column shows other side of things - whether or not you have allocated a slot to the peer in order to upload to it). There is a column in the "peers" sub-tab that shows your "choked" status (note this is different from the "choking" column. When you don't have a slot you are "choked". When you have been allocated a slot you have been "unchoked" by the peer. Periodically it will re-allocate the slots to different peers. A given seed will only upload to a relatively small number of peers at a time to avoid spreading its upload bandwith too thinly - it uses a limited number of upload slots to achieve this. This is because bittorrent uses the concept of "upload slots". Upload slot allocationĮven when you are connected to a seed it won't necessarily upload to you. Often when a popular download becomes available for the first time this will be the case. For example if there are 10 seeds and 100 peers then each seed's upload is shared across 10 peers. This is because the seeds' upload bandwidth is spread across all the downloading peers. Poor seed-to-peer ratioĮven when there are seeds available if there are a large number of peers (also known as "leechers") attempting to also download then your download may be slow. If the "peers" sub-tab shows attempted to connections (indicated by a state of "connecting") that disappear after a while then this generally means that the peers are no longer available - this is quite common. You can see the actual seeds you are connected to by checking the "peers" sub-tab. If the swarm has zero or a low number of seeds then there are few potential sources of the data you want to download. Note that the values reported aren't guaranteed to be accurate but it is a good starting point. Check the "seeds" column to see how many seeds each source is reporting. It may also use decentralised trackers (the built in BiglyBT tracker, the "mainline DHT" tracker if you have this installed and the I2P tracker if the download uses this network). Depending on your download it will probably have one or more trackers, these can be seed in the "sources" sub-tab for the download. ![]() A healthy swarm will have a number of seeds that have the complete download and are available to send you data. The first thing to do is evaluate the health of the swarm. This is a common question and there is no simple answer as many things can influence your upload and download rates.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |